DISPLAY FUNCTIONS MODE DEFINITION For a LaserJet II or newer printer, display functions will cause the printer to print out all of the control codes and escape sequences instead of executing them. To turn on display functions mode, create a file in a text editor and copy the file to the printer. The following example is created in EDIT. TURN ON DISPLAY FUNCTIONS LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT At the DOS prompt, C:> type EDIT to go into the DOS editor followed by a filename of your choice, then enter the following PCL commands. EcE Printer Reset Ec&s0C Enables end of line wrap Ec(10U Identifies the PC-8 symbol set EcY Turns on display functions You can either print the file from EDIT or save and exit back to the DOS prompt and copy the file to the printer. Now send a job to the printer. Graphic characters will appear showing the commands your printer has received. To turn off display functions you can: do a 09 RESET on the printer, turn the printer off and back on, or send a Display Functions Off Code. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this
file: /Techref/language/pcl/lj1614.htm, 1KB, , updated: 2003/9/29 16:35, local time: 2024/8/31 23:54,
18.217.204.181:LOG IN
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://massmind.org/Techref/language/pcl/lj1614.htm"> language pcl lj1614</A> |
Did you find what you needed? |
Welcome to massmind.org! |
Welcome to massmind.org! |
.