please dont rip this site

Sherline CNC Mill

Note, remote connect to the Chilipeppr ws: address, not wss:. E.g. ws:192.168.1.17:8989/ws. Be sure to select grbl FIRST before connecting to the port.

Todo:

grbl 1.1f Settings:
$0=10 (step pulse length, microseconds)
$1=25 (idle timeout, milliseconds)
$2=0 (step pulse invert mask, ....xyz)
$3=6 (direction invert mask, ....XYz)
$4=1 (enable invert mask, ....xyZ)
$5=0 (limit switch invert mask )
$6=0 (probe pin invert mask )
$10=1 (status report mask, position, no buffer)
$11=0.010 (junction deviation, mm)
$12=0.002 (arc tolerance, mm)
$13=1 (report in inchse, not mm)
$20=0 (soft limits disabled)
$21=1 (hard limits enabled)
$22=0 (homing disabled)
$23=0 (homing direction invert map, ...+++)
$24=25.000 (homing set speed, mm/minute)
$25=500.000 (home seek speed, mm/minute)
$26=250 (home switch debounce, milliseconds)
$27=1.000 (after home pull off, mm)
$30=1000 (max spindle speed, rpm)
$31=0 (min spindle speed, rpm)
$32=0 (laser mode, disabled)
$100=1259.843 (X steps/mm)
$101=1259.843 (Y steps/mm)
$102=1259.843 (Z steps/mm)
$110=500.000 (X max speed mm/minute)
$111=500.000 (Y max speed mm/minute)
$112=500.000 (Z max speed mm/minute)
$120=10.000 (X Acceleration, mm/sec^2)
$121=10.000 (Y Acceleration, mm/sec^2)
$122=10.000 (Z Acceleration, mm/sec^2)
$130=200.000 (X Max travel, mm)
$131=200.000 (Y Max travel, mm)
$132=200.000 (Z Max travel, mm)
+
file: /Techref/member/JMN-EFP-786/sherline-cnc-mill.htm, 1KB, , updated: 2022/2/21 16:51, local time: 2024/12/13 04:17, owner: JMN-EFP-786,
TOP NEW HELP FIND: 
18.97.14.84:LOG IN

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://massmind.org/Techref/member/JMN-EFP-786/sherline-cnc-mill.htm"> Sherline CNC Mill</A>

After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?